Electrostatic Spray System & Water Free Releasing Agent For Die Casting
Exhibitor: SUN WISDOM CO., LTD.
Booth No: I426
In die casting industry, we use water-dilution type of releasing agent, so various issues are occurred:
1.Using diluted releasing agent to lower the temperature of dies, makes cycle time longer, and dies temperature become too cold.
2.Using too much volume of releasing agent, water flows everywhere, and used releasing agent need to do sewage treatment.
3.Spraying and blow-dry process will generate much noise.
4.Residual moisture on the die will become pin hole defects of castings.
Our innovative system that only few releasing agent is needed in each cycle was released, and merits are shown as below:
＃Productivity: Cycle time will be shorter
＃Cost : Die lifetime will be 3 times above longer than before.(Based on actual experience data)
＃Casting Quality: No internal holes caused by residual moisture, and fluidity will be improved thus quality of casting will be better.
＃Environment improvement: Cutting down noise, fluid water, sewage treatment, and mist collection
Products you may be interested in